Procedure - Activation of the COM21 cable modem

1. Pluging the cable modem câble with the coax cable.

• Look at the connector behind the cable modem.

• Plus the coax wire in the "RF" connector.

2. Pluging the computer with the cable modem.

• Plug the RJ-45 wire of your computer to the "10BASE-T" connector behind the cable modem.

• Check that the other end of wire RJ45 is well connected with your network adapter of your computer.

3. Pluging the power of the cable modem.

• Plug the power cord in "DC IN 12V 1A" behind the cable modem.

4. Auto initialisation of the cable modem.

When the modem start to initialise, light will appear like this :

1. Light <<CABLE>> will flashing slowly until <<foward>> signal are found.

2. Light <<CABLE>> Will flashing quickly until <<reverse>> signal are found.

3. Light <<CABLE>> will remain without flashing and the modem will take is configuration on the server of COGECO.

4. Light <<LAN>> is ON when pc is ON and the modem is pluging with the pc with the RJ-45 wire.

When <<POWER, CABLE and PC>> light is ON, the modem is synchronised.

Note: If <<CABLE>> light don't go ON, contact the technical support of COGECO at 1-800-665-3131 ou at (819) 693-3131 from Trois-Rivières.

Return to index